跳转至主要内容

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

port-channel mode

Configure the LACP port channel mode.

Syntax

port-channel number mode [active] [passive] [off]

Parameters

number	Enter the keywords `number` then a number.
active	Enter the keyword `active` to set the mode to the active state. NOTE: LACP modes are defined in Usage Information.
passive	Enter the keyword `passive` to set the mode to the passive state. NOTE: LACP modes are defined in Usage Information.
off	Enter the keyword `off` to set the mode to the off state. NOTE: LACP modes are defined in Usage Information.

Defaults

off

Command Modes

INTERFACE

Supported Modes

Programmable-Mux (PMUX)

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.4(0.0)	Supported on the FN I/O Aggregator.
9.2(0.0)	Introduced on the M I/O Aggregator.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

LACP Modes

Mode	Function
active	An interface is in an active negotiating state in this mode. LACP runs on any link configured in the active state and also automatically initiates negotiation with other ports by initiating LACP packets.
passive	An interface is not in an active negotiating state in this mode. LACP runs on any link configured in the passive state. Ports in a passive state respond to negotiation requests from other ports that are in active states. Ports in a passive state respond to LACP packets
off	An interface cannot be part of a dynamic port channel in off mode. LACP does not run on a port configured in off mode.