跳转至主要内容

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

debug ip icmp

View information on the internal control message protocol (ICMP).

Syntax

debug ip icmp [ interface] [count value]

To disable debugging, use the no debug ip icmp command.

Parameters

interface

(OPTIONAL) Enter the following keywords and slot/port or number information:

For the management interface, enter the keyword ManagementEthernet then the slot/port information. The slot range is 0 and the port range is 0.
For a 10 Gigabit Ethernet interface, enter the keyword TenGigabitEthernet then the slot/port information.
For VLAN, enter the keyword vlan then by a number from 1 to 4094.

count value

(OPTIONAL) Enter the keywords count then the count value. The ranges from 1 to 65534. The default is Infinity.

Command Modes

EXEC Privilege

Supported Modes

All Modes

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.4(0.0)	Supported on the FN I/O Aggregator.
8.3.17.0	Supported on the M I/O Aggregator.

Usage Information

To stop packets from flooding the user terminal when debugging is turned on, use the count option.

Example

ICMP: echo request rcvd from src 40.40.40.40
                                          ICMP: src 40.40.40.40, dst 40.40.40.40, echo reply
                                          ICMP: src 40.40.40.40, dst 40.40.40.40, echo reply
                                          ICMP: echo request sent to dst 40.40.40.40
                                          ICMP: echo request rcvd from src 40.40.40.40
                                          ICMP: src 40.40.40.40, dst 40.40.40.40, echo reply
                                          ICMP: src 40.40.40.40, dst 40.40.40.40, echo reply
                                          ICMP: echo request sent to dst 40.40.40.40: