跳转至主要内容

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

ip ospf cost

Change the cost associated with the OSPF traffic on an interface.

Syntax

ip ospf cost cost

To return to default value, use the no ip ospf cost command.

Parameters

cost

Enter a number as the cost. The range is from 1 to 65535.

Defaults

The default cost is based on the reference bandwidth.

Command Modes

INTERFACE

Supported Modes

Full—Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

If this command is not configured, cost is based on the auto-cost command.

When you configure OSPF over multiple vendors, to ensure that all routers use the same cost, use the ip ospf cost command. Otherwise, OSPF routes improperly.

Related Commands

auto-cost — controls how the OSPF interface cost is calculated.