跳转至主要内容

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

protocol spanning-tree rstp

To configure RSTP, enter RSTP mode.

Syntax

protocol spanning-tree rstp

To exit RSTP mode, use the exit command.

Defaults

Not configured

Command Modes

CONFIGURATION

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

RSTP is not enabled when you enter RSTP mode. To enable RSTP globally on the system, use the no disable command from RSTP mode.

Example

Dell(conf)#protocol spanning-tree rstp
                                             Dell(config-rstp)##no disable

Related Commands

disable — disables RSTP globally on the system.