跳转至主要内容

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

ipv6 address

Configure an IPv6 address to an interface.

Syntax

ipv6 address { ipv6-address prefix-length}

To remove the IPv6 address, use the no ipv6 address { ipv6-address prefix-length} command.

Parameters

ipv6-address prefix-length

Enter the IPv6 address in the x:x:x:x::x format then the prefix length in the /x format. The range is from /0 to /128.

NOTE: The :: notation specifies successive hexadecimal fields of zeros.

Defaults

none

Command Modes

INTERFACE

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

If two addresses are configured, delete an existing address before configuring a new address.
If the last manually-configured global IPv6 address is removed using the “no” form of the command, the link-local IPv6 address is removed automatically.
IPv6 addresses on a single management interface cannot be members of the same subnet.
IPv6 secondary addresses on management interfaces across platform must be members of the same subnet.
IPv6 secondary addresses on management interfaces should not match the virtual IP address and should not be in the same subnet as the virtual IP.

Example

Dell(conf)#interface tengigabitethernet x/x
                                             Dell(conf-if-te-x/x)#ipv6 address ?
                                             X:X:X:X::X IPv6 address
                                             Dell(conf-if-te-x/x)#ipv6 address 2002:1:2::3 ?
                                             <0-128> Prefix length in bits
                                             Dell(conf-if-te-x/x)#ipv6 address 2002:1:2::3 /96 ?
                                             Dell(conf-if-te-x/x)#ipv6 address 2002:1:2::3 /96
                                             Dell(conf-if-te-x/x)#show config