跳转至主要内容

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

show running-config monitor session

Displays the running configuration of all monitor sessions or a specific session.

Syntax

show running-config monitor session { session-ID}

To display the running configuration for all monitor sessions, use the show running-config monitor session command.

Parameters

session-ID

(OPTIONAL) Enter a session identification number. The range is from 0 to 65535.

Defaults

none

Command Modes

EXEC Privilege

Supported Modes

All Modes

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.4(0.0)	Supported on the FN I/O Aggregator.

Usage Information

The monitoring command is saved in the running configuration at the Monitor Session mode level and can be restored after a chassis reload.

Example

Dell#show run monitor session
                                             !
                                             monitor session 5
                                             source TenGigabitEthernet 0/4 destination TenGigabitEthernet 0/5 direction rx
                                             !
                                             monitor session 20
                                             source TenGigabitEthernet 0/3 destination TenGigabitEthernet 0/2 direction both
                                             Dell#
                                             Dell#show run monitor session 20
                                             !
                                             monitor session 20
                                             source TenGigabitEthernet 0/3 destination TenGigabitEthernet 0/2 direction both
                                             Dell#

Related Commands

monitor session — creates a session for monitoring.

show monitor session — displays a monitor session.