跳转至主要内容

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

neighbor bfd disable

Explicitly disable a BFD session with a BGP neighbor or a BGP peer group.

Syntax

neighbor { ip-address | peer-group-name} bfd disable

Parameters

ip-address	Enter the IP address of the BGP neighbor that you want to explicitly disable for BFD sessions in dotted decimal format (A.B.C.D).
peer-group-name	Enter the name of the peer group that you want to explicitly disable for BFD sessions.

Defaults

none

Command Modes

ROUTER BGP

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

When you explicitly disable a BGP neighbor for a BFD session with the neighbor bfd disable command:

The neighbor does not inherit the global BFD disable values configured with the bfd all-neighbor command or configured for the peer group to which the neighbor belongs.
The neighbor only inherits the global timer values configured with the bfd all-neighbor command: interval, min_rx, and multiplier.

When you remove the Disabled state of a BFD for a BGP session with a specified neighbor by entering the no neighbor bfd disable command, the BGP link with the neighbor returns to normal operation and uses the BFD session parameters globally configured with the bfd all-neighbor command or configured for the peer group to which the neighbor belongs.

Related Commands

bfd all-neighbors — enables BFD sessions with all neighbors discovered by Layer 3 protocols.

bfd neighbor — explicitly enables a BFD session with a BGP neighbor or a BGP peer group.

show bfd neighbors — displays the BFD neighbor information on all interfaces or a specified interface.