跳转至主要内容

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

port-channel-protocol lacp

Enable LACP on any LAN port.

Syntax

port-channel-protocol lacp

To disable LACP on a LAN port, use the no port-channel-protocol lacp command.

Command Modes

INTERFACE

Supported Modes

Programmable-Mux (PMUX)

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.4(0.0)	Supported on the FN I/O Aggregator.

Example

Dell(conf)#interface TenGigabitethernet 0/5
                                             Dell(conf-if-te-0/5)#no shutdown
                                             Dell(conf-if-te-0/5)#port-channel-protocol lacp
                                             Dell(conf-if-te-0/5-lacp)#port-channel 32 mode active
                                             ...
                                             Dell(conf)#interface TenGigabitethernet 0/6
                                             Dell(conf-if-te-0/6)#no shutdown
                                             Dell(conf-if-te-0/6)#port-channel-protocol lacp
                                             Dell(conf-if-te-0/6-lacp)#port-channel 32 mode active