跳转至主要内容

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

ipv6 pim join-filter

Permit or deny PIM Join/Prune messages on an interface using an access list. This command prevents the PIM-SM router from creating state based on multicast source and/or group.

Syntax

ipv6 pim join-filter access-list

Parameters

access-list	Enter the name of an extended access list.
in	Enter the keyword `in` to apply the access list to inbound traffic.
out	Enter the keyword `out` to apply the access list to outbound traffic.

Defaults

none

Command Modes

INTERFACE

Supported Modes

Full—Swtich

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the MXL 10/40GbE Switch IO Module.

Example

Dell(conf)#ipv6 access-list JOIN-FIL_ACL
                                             Dell(conf-ipv6-acl)#permit ipv6 165:87:34::0/112 ff0e::225:1:2:0/112
                                             Dell(conf-ipv6-acl)#permit ipv6 any ff0e::230:1:2:0/112
                                             Dell(conf-ipv6-acl)#permit ipv6 165:87:32::0/112 any
                                             Dell(conf-ipv6-acl)#exit
                                             Dell(conf)#interface tengigabitethernet 0/84
                                             Dell(conf-if-te-0/84)#ipv6 pim join-filter JOIN-FIL_ACL in
                                             Dell(conf-if-te-0/84)#ipv6 pim join-filter JOIN-FIL_ACL out