跳转至主要内容
退出

欢迎访问戴尔

我的帐户
  • 快速、轻松地下订单
  • 查看订单并跟踪您的发货状态
  • 创建并访问您的产品列表
  • 使用“Company Administration”（公司管理），管理Dell EMC站点、产品和产品级联系人。
登录 创建帐户 登录Premier 合作伙伴计划登录
联系我们

您的 Dell.com 购物车

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

IPv6 Access Control Lists (IPv6 ACLs)

IPv6 ACLs and IPv6 Route Map commands are supported on Dell Networking switch.

Important Points to Remember

  • Certain platforms require manual CAM usage space allotment. For more information, refer to the cam-acl (Configuration) command.
  • Egress IPv6 ACL and IPv6 ACL on the Loopback interface is not supported.
  • Reference to an empty ACL permits any traffic.
  • ACLs are not applied to self-originated traffic (for example, Control Protocol traffic not affected by IPv6 ACL because the routed bit is not set for Control Protocol traffic and for egress ACLs the routed bit must be set).
  • You can use the same access list name for both IPv4 and IPv6 ACLs.
  • You can apply both IPv4 and IPv6 ACLs on an interface at the same time.
  • You can apply IPv6 ACLs on physical interfaces and a logical interfaces (Port-channel/VLAN).
  • Non-contiguous masks are not supported in source or destination addresses in IPv6 ACL entries.
  • Because the prefix mask is specified in /x format in IPv6 ACLs, inverse mask is not supported.

对此内容评级

准确性
有用性
易理解性
这篇文章对您有帮助吗？
0/3000 characters
  请提供评级（1-5星）。
  请提供评级（1-5星）。
  请提供评级（1-5星）。
  请选择这篇文章是否有帮助。
  注释中不得包含以下特殊字符：<>()\