跳转至主要内容

Dell PowerEdge FN I/O Module Command Line Reference Guide 9.10(0.0)

PDF

policy-map-input

Create an input policy map.

Syntax

policy-map-input policy-map-name [layer2]

To remove an input policy map, use the no policy-map-input policy-map-name [layer2] command.

Parameters

policy-map-name	Enter the name of the policy map in character format (32 characters maximum).
layer2	(OPTIONAL) Enter the keyword `layer2` to specify a Layer 2 Class Map. The default is Layer 3.

Defaults

Layer 3

Command Modes

CONFIGURATION

Supported Modes

Full–Switch

Command History

Version	Description
9.9(0.0)	Introduced on the FN IOM.
9.2(0.0)	Introduced on the M I/O Aggregator.
8.3.16.1	Introduced on the MXL 10/40GbE Switch IO Module.

Usage Information

The input policy map is used to classify incoming traffic to different flows using class-map, QoS policy, or incoming packets DSCP. This command enables Policy-Map-Input Configuration mode (conf-policy-map-in).

Related Commands

service-queue — assigns a class map and QoS policy to different queues.

policy-aggregate — allows an aggregate method of configuring per-port QoS using policy maps.

service-policy input — applies an input policy map to the selected interface.