SupportAssist Enterprise Version 1.0 User's Guide

Manually configuring the alert destination of a chassis by using the web interface

1. In the system tree, go to Chassis Overview, and then click Alerts > Chassis Events.
   The Chassis Events page is displayed.
2. Under Chassis Event Filters Configuration section, select Enable Chassis Event Alerts option to enable alert generation.
3. Under the Chassis Event List section, select the Enable Alert option on the column header to generate alerts for all events.
4. In the system tree, go to Chassis Overview, and then click Alerts > Trap Settings.
   The Chassis Event Alert Destinations page is displayed.
5. Perform the following:
   • In the Destination field, enter the IP address of the server where SupportAssist Enterprise is installed.
   • In the Community String field, enter a valid community string to which the server where SupportAssist Enterprise is installed belongs.
     NOTE: CMC uses a default SNMP community string as public. To ensure higher security, it is recommended to change the default community string and set a value which is not blank.
   • Under Enabled, select the check box corresponding to the IP address of the server where SupportAssist Enterprise is installed.
6. Click Apply to save the settings.
7. To test whether the destination IP address is receiving the SNMP traps, click Send in the Test SNMP Trap column.

   The IP alert destinations are configured.