Zu den Hauptinhalten

Integrated Dell Remote Access Controller 9 Version 3.30.30.30 User's Guide

PDF

Configuring iDRAC to use SOL using RACADM

To configure IPMI Serial over LAN (SOL):

Enable IPMI Serial over LAN using the command.
```
racadm set iDRAC.IPMISol.Enable 1
```
Update the IPMI SOL minimum privilege level using the command.
```
racadm set iDRAC.IPMISol.MinPrivilege <level>
```
Parameter Privilege level
<level> = 2 User
<level> = 3 Operator
<level> = 4 Administrator
NOTE To activate IPMI SOL, you must have the minimum privilege defined in IMPI SOL. For more information, see the IPMI 2.0 specification.
Update the IPMI SOL baud rate using the command.
```
racadm set iDRAC.IPMISol.BaudRate <baud_rate>
```
NOTE To redirect the serial console over LAN, make sure that the SOL baud rate is identical to the managed system’s baud rate.
Parameter Allowed values (in bps)
<baud_rate> 9600, 19200, 57600, and 115200.
Enable SOL for each user using the command.
```
racadm set iDRAC.Users.<id>.SolEnable 2
```
Parameter Description
<id> Unique ID of the user

NOTE To redirect the serial console over LAN, ensure that the SOL baud rate is identical to the baud rate of the managed system.